Then, locate the pull tabs near the back of the lid for both compartments and use them to remove them. To clean the detergent drawer of your washer, begin by holding down the release lever on the inner part of the drawer and pulling it out to remove it. Turn on the tap, and your Samsung washer is ready to use.Ĭlean the Dispenser Drawer (Model WF50A8800AV Only).Reinsert the filters and reinstall the L-shaped arm fitting into the washing machine, ensuring all connections are tight and secure.Rinse them thoroughly under running water until they are clean.Use pliers to remove the mesh filters from the water supply intake carefully.Cover the hose connection with a cloth to prevent water from escaping due to air pressure.Turn off the water supply for your Samsung washer by disconnecting the L-shaped arm fitting for the water supply hose.If the 4c error code persists, you may need to replace the hoses. Reattach the hoses, plug the washing machine back in, and run a test cycle. If any are visible, remove them by hand or with a wire brush. If they appear intact, disconnect the fill hoses from the machine and check for blockages along their length. Inspect the hoses for any cracks, leaks, kinks, or visible damage. Next, disconnect the water hoses from the faucets and the machine. To check, turn off the water and unplug the washing machine. If the above steps do not fix the problem, you may need professional help from an expert technician or contact customer service for additional support. The drain hose should not be more than 6 inches in the drainpipe and should not form an airtight connection. A loose or incorrectly installed drain hose could be the cause of the issue. Check that the drain hose is correctly inserted and secure.Turn the water on and make sure it is fully open for both hot and cold water lines. Make sure the hot and cold water hoses are connected to the corresponding inlets on the washing machine.Also, ensure that there are no objects blocking the hoses, such as furniture or cabinets, which could lead to reduced water flow. Gently straighten any kinks, but replace a damaged hose. Check for any kinks or bends that may be preventing an adequate flow of water, and make sure that the hose itself is undamaged and not leaking.Move the machine forward to gain access to the water hoses.Power off and unplug the washing machine from the mains to access its components safely.If this is not the case, here are some steps you can take to diagnose and fix the issue: The water supply should have a pressure of between 0.5 and 8 bar. To ensure the appliance works correctly, make sure the water valve is fully open and turned on. Are the Hoses Connected Correctly?Ī problem with the water supply to a Samsung washing machine is usually caused by low water pressure or a low flow rate. Here’s a more detailed look at the steps and tools needed to fix the 4c error code and get your Samsung washing machine running smoothly again. Finally, if all else fails, you may need to replace the solenoid valve. You should also check for any blockages in the filter or hose and replace them if necessary. To resolve this issue, first, check that the water supply is turned on and that the hoses are connected properly. This could be due to low water pressure, a blocked filter or hose, or a faulty solenoid valve. The 4C error code indicates that there is an issue with the water supply to your washing machine. Have you ever seen the Samsung Washer Code 4c appear on your washing machine? If so, you may be wondering what it means and how to fix it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |